Sheets and Shop Drawings improvement to Takeoff: automatic scale detection and assignment as soon as you upload your plans, including automatic handling of sheets that contain more than one scale.
Automatic Sheet Scale Selection
Now you can have sheet scales set automatically as soon as you upload your plans, so you no longer need to manually assign a scale to each sheet. When a single sheet contains multiple scales, INNERGY automatically creates scale areas with the correct scale applied to each region.
How to use it
Upload your plan set into Takeoff as usual — there's no separate button to trigger detection; it runs automatically as part of processing your sheets.
INNERGY scans each sheet that doesn't already have a scale set and assigns the detected scale for you. Sheets that already have a scale applied are left alone — detection doesn't overwrite an existing calibration.
If a sheet contains more than one scale (for example, a floor plan next to a detail drawn at a different scale), INNERGY divides the sheet into Scale Areas — the same tool you'd use to set localized scales by hand — and applies the correct scale to each region automatically.
Sheets or scale areas that were set by AI show a "This scale was detected by AI. Please review it." tooltip. Check flagged sheets before relying on measurements taken from them, and adjust the scale manually if it's wrong.
Permissions: No new permission is introduced — this feature uses your existing Takeoff sheet access.